THE Gear Locker (Rifle Hanger Double)

For Harbor Freight (US General 22" end locker) ONLY

Mounting Width: 7.70"

You will need one base insert to mount this product - You can combine multiple items on one dowel rod with one base insert. Refer to the mounting width of each product you wish to purchase and compare it to the available mounting width for one dowel rod (product page description). 

The rifle hanger is a necessity for me. I used to just lean my rifle on the side of the locker but, if you've ever had your rifle fall over in the middle of the night in a steel locker, you'll understand why I made this accessory. 

• Holds 2 rifles side by side 
• For reference are the following pictured rifles: BCM 11.5" with full size can, DBAL, Holosun red dot on a Unity riser and a BCM airsoft clone with the exact same setup
  
• Two opening gates to lock your rifle into place, locking retention dimples to keep the gates closed 
• Firm push/pull to lock/ unlock 
• Opening size is 3.1" X 3.9"
• Simple hinged design uses spare filament for the hinge pin, easy to replace when needed 

We do not include the dowel rod! You will need to source your dowel rods from Home Depot or other hardware store. The size that you must use is 3/4" wooden dowel rod. These rods must be cut down to 19.5" in order to fit properly and lock into place. Cutting the rods too short will cause them to not lock into the frame of the locker, cutting them too long will not let you insert them into the base. Home Depot will cut them for you in store if you ask! 

• You can paint your dowel rods if you'd like! Do some light sanding first and use a light coat, painting the rods too thick can make them difficult to insert into the mounts 

Please note that some products  may have small imperfections or visible seams since 3D printing is not perfect and seams are a natural occurrence as the nozzle changes direction between layers. Products may also very slightly from product photos as I improve on the designs and release newer and better iterations. 

Material: Additive manufacturing with PLA CF (this is not a high temp material and should not be stored in direct sunlight). 

Warranty: If an item breaks and falls within our warranty/ replacement policies, reach out to me at 111fathoms@gmail.com  with your order number and pictures and I will get a replacement or refund sent to you ASAP.